AUDI A8 D4 Transmission fluid and filter change (ATF fill steps in the description)/Замена масла

– Fill the ATF
– Move the selector lever to “P”.
– Start the engine, wait 20 seconds, and then turn it off.
– Fill the ATF again until it starts to leak out of the hole.
– Start the engine.
– Fill the ATF again until the ATF starts to leak out of the check and fill hole.
– Tighten the old plug for the ATF check and fill hole.
– While pressing the brake pedal and with the vehicle idling, shift through all the selector lever positions (“P”, “R”, “N”, “D/S”) leaving each position engaged for 3 seconds.
– Move the selector lever to “P”.
– Check the ATF level and correct it if necessary.

The ATF level is checked at the ATF check and fill hole.
The ATF level is correct if a small amount of fluid drips out of the inspection and fill opening (this is normal as the fluid expands as it heats up) at an ATF temperature between 35 ° and 45 °C (95 ° and 113 °F), for hot countries 50 °C (122 °F).