Build a CNC Controller with Arduino, TB6600 and GRBL

How to configure a new CNC? After building the C-Beam CNC which I got as a mechanical build from a Chinese maker it was time to start with the electronics. It took me a while to understand what components are required and how I should go about it. Because all these details were not available at one place I have decided to write this post in detail to explain them. Hope you enjoy it.

-----------------//-----------------
Written Tutorial: https://goo.gl/FvU1za
Download the schematic: https://goo.gl/akvbUe
-----------------//-----------------
REQUIRED MATERIALS:
Stepper Motor: https://goo.gl/Qsu2Ba
TB6600 Stepper Motor Driver: https://goo.gl/rryycT
Arduino Uno: https://goo.gl/in5QcH
Power Supply: https://goo.gl/3xigZV
Emergency Stop Switch: https://goo.gl/b9Et5V
Router & Power Switch: https://goo.gl/xtFt76
4 Pin Connectors: https://goo.gl/qcmXqr
AC Power Connector: https://goo.gl/B2KnEJ
C-Beam CNC Mechanical Build: https://goo.gl/qfn2FJ
-----------------//-----------------
VIDEOS:
Finding stepper motor wires: https://goo.gl/iBiiGv
GRBL: https://goo.gl/fFQTRQ
Universal Gcode Sender: https://goo.gl/UemxUu
Easel: https://goo.gl/85hcPG
-----------------//-----------------
FOLLOW ME ON:
  / kalaakaar.in  
  / kalaakaar.in  
  / mr_jcrp  
-----------------//-----------------
MORE PROJECTS TUTORIALS and POSTS
http://www.kalaakaar.in/builds
-----------------//-----------------
MUSIC: Bit Quest (incompetech.com)
-----------------//-----------------