How to install the CANChecked Gauge into your EVO-X

This instructional video applies for the following CANChecked Gauge Kit
https://shop.powertune.com.au/canchec...

Please use the below timestamps to navigate through the instructional video.

00:00 Intro : Installing the CANChecked Gauge into your EVO-X
00:25 Step 1 : Removing the Glovebox and Kick Panels
00:50 Step 2 : Running your wires through the console
01:34 Step 3 : Locating the grommet to pass the cables through to the engine bay
02:04 Step 4 : Running the cables through from the engine bay side
02:54 Step 5 : Removing the factory EVO-X Aircon vent
03:16 Step 6 : Remove the Console Panels
05:08 Step 7 : Pulling apart the factory Aircon vent
06:30 Step 8 : Installing the CANChecked Gauge into the Aircon vent
07:10 Step 9 : Routing the supplied CANCecked cables through the Aircon vent
08:54 Step 10 : How to route the CANChecked wires through your dash
10:27 Step 11 : Plugging in the supplied cables into the CANCecked Gauge
10:48 Step 12 : Refit the Console Trim and Kick Panels
12:56 Explaining Page-1 on the CANChecked Gauge
13:30 Explaining Page-2 on the CANChecked Gauge
14:06 Explaining Page-3 on the CANChecked Gauge
14:16 Explaining Page-4 on the CANChecked Gauge
14:45 Explaining Page-5 on the CANChecked Gauge
15:00 Explaining Page-6 on the CANChecked Gauge
15:27 Explaining Page-7 on the CANChecked Gauge
15:50 Explaining Page-8 on the CANChecked Gauge
16:16 Explaining Page-9 on the CANChecked Gauge
16:37 Explaining Page-10 on the CANChecked Gauge
17:14 Explaining the options and settings in the CANChecked Gauge
18:26 Settings you should check out before using the CANChecked Gauge
20:04 Explaining the base file features of the CANChecked Gauge
20:30 Explaining OBD Port operations
21:05 Adjusting for different/custom gear ratios
21:56 Explaining the Red Light Limiter in the CANChecked Gauge
22:18 Explaining the Slpash Screen settings
22:39 Explaining the Start Screen options in the CANChecked Gauge
22:58 Is your page switching every time you rev the engine?
24:02 CANChecked Gauge in Demo mode