Thonny, Installing MicroPython & Hello World | Raspberry Pi Pico Workshop: Chapter 1.6

🔗 The full course : https://core-electronics.com.au/cours...

In this video, we are going to install Thonny and then install MicroPython on the Pico. Once we have that setup, we will finally get into some code and learn the *print function*, and while doing that we will get ourselves familiar with the Thonny environment and some basic Micropython *Syntax*.

🔧🔨🧰 Hardware featured in this guide:

Raspberry Pi Pico:
https://core-electronics.com.au/catal...
The Pico Variants:
https://core-electronics.com.au/raspb...

💡❓ If you have any questions about this content or want to share a project you're working on head over to our maker forum: http://coreelec.io/forum

0:00 Intro
0:25 Installing Thonny and MicroPython
1:44 Selecting the Com Port
2:22 A look at Thonny
3:15 The print() Command
4:37 Basic Syntax

🌏🦘 Core Electronics is located in the heart of Newcastle, Australia. We're powered by makers, for makers. Drop by if you are looking for:

• Raspberry Pi https://core-electronics.com.au/raspb...
• Arduino https://core-electronics.com.au/ardui...
• Sparkfun https://core-electronics.com.au/brand...
• Adafruit https://core-electronics.com.au/brand...
• Pololu https://core-electronics.com.au/brand...
• DFRobot https://core-electronics.com.au/brand...

The following trademarks are owned by Core Electronics Pty Ltd:

"Core Electronics" and the Core Electronics logo
"Makerverse" and the Makerverse logo
"PiicoDev" and the PiicoDev logo
"GlowBit" and the GlowBit logo