Radiolink AT10II/AT9S/AT9S Pro Mode 2(Left Hand Throttle) Change to Mode1(Right Hand Throttle)

Radiolink AT10II/AT9S/AT9S Pro Mode 2(Left Hand Throttle) Change to Mode1(Right Hand Throttle)
At now, it's mode 2 left hand throttle
Preparation: screwdriver, tweezers.
1. unscrew the four screws on the back of the remote control with a screwdriver.
2.taking the back cover off and unplugging the emulator port cable connected to the mainboard.
3. remove the right pressure plate.
4. Take out the left-hand side of the centering kit and the spring, the right-hand side is already fitted with the centering kit from the factory, hold the left-hand side of the spring with tweezers and hook one end to the hook in the lower right-hand corner of the cradle and one end to the recess of the centering kit.
5. Once installed, test the right hand side (corresponding to the left hand side of the remote control) to see if it is back in the centre.
6. install the pressure plate to the left (corresponding to the right hand of the remote control) so that the American hand is replaced by the Japanese hand.
7. Open the main interface, press MODE to enter the "Basic Menu", then tap on "System Settings".
8. Move the cursor to "joystick mode", turn the "PUSH" key to select the joystick mode, Now the American hand is Mode 2, so we move the wheel to select mode 1, change to the Japanese hand.
9. After the cursor is moved away, it will be saved automatically, press "END" to return.
Now,it’s mode1 right hand throttle

How to calibrate the transmitter
1.Press the END key and the PUSH key at the same time, and then turn on the AT10;
2.Enter the calibration stick interface；
3.First calibrate CH1, press the END key to clear the value, turn the stick to the left, and press the Mode key after recognition OK；
4.Move cursor lever down, press the END key to clear the value, turn the stick to the middle place, and press the Mode key after recognition OK；
5.Move cursor lever down, press the END key to clear the value, turn the stick to the right, and press the Mode key after recognition OK；
6.Calibrate other channels by analogy.(All values are ok)

#rctransmitter #fpvracing #radiolink