Can the Anycubic Kobra 3 Combo multi colour 3D Printer print out of the box

Can you print straight away after the self setup with the Anycubic Kobra 3 Combo multi colour 3D printer ? I tried it to see if it can be done without changing any settings on the very first print after the self test. I did a direct print from the printers screen which they give you as test prints and I was presently surprised at the outcome.

I then used the Anycubic Prusa slicer to do more prints without messing with any of the z, y and x offsets. After I updated the firmware to the lastest version the printer would do a self level before each print. The only thing I changed in the slicer was the layer levels and the speed of printing and again I was very surpised at the outcome.

Another thing was the whole process of setting up the software to run the printer and the self tests the printer does, took less than 20 minutues and I was printing for the very first time.

I have had one problem with the printer so far which was after a print I did a self level and it did completley the opposite of leveling the bed. After another go at the self level it corrected itself without me having to change any of the offsets manually as the printer did it for me.

For a beginer I have found this Anycubic Kobra 3 printer very easy to build, setup and use.

PS: I have only tested one colour prints and not multi colour on this video.