3 PTAC MENUS THAT WILL HELP YOU DIAGNOSE PROBLEMS

Today I will go over some menus that have really helped me out of a jam with Amana ptacs. Hopefully this can help some peps out there. Stayed tuned and more videos will come showing some more menus and stuff you can do with the Amana PTAC. Thanks for watching and come along shall we BELOW ARE THE STEPS:
COMPLETE SERVICE MANUAL: https://hvacdirect.com/hvac/pdf/AMANA...

Master RESET
Remove the front panel Turn off the master switch (located on the far bottom left of the control board)
Press and hold the cool and heat buttons down while you turn on the master switch
Continue holding the buttons down till you see the red light show up beside the Off button You have now cleared all errors and settings back to Factory conditions.

Diagnostic Test
Press and hold the up and down arrow buttons
Press the heat button twice
The unit will cycle low fan high fan compressor all lights on display will light then goes out then into low heat then high heat then Off.

Configuring A Ptac for wired thermostat control
Press and hold the up and down arrow buttons
Click the off button twice
Press heat then use the up and down arrows to select L5
This will now put the unit into wired thermostat control
to reverse this do everything Above but select 0 instead of L5

THERMISTOR DATA TEST

Hold the up and down arrow button
Press Cool twice
Press the fan button this will now cycle though the temps on every sensor.