Onsite metal fabrication - four-piece duct transition (Mechanical / sheet metal training

Common tools used are linked in the description below;
Test questions for staff members coming soon

Tools used;
Wiss Scissors
https://amzn.to/3HKBKP5

Sharpie
https://amzn.to/3lebL9K

Malco 12F 12 in. Folding Tool
https://amzn.to/3JG0U1V

Malco 24F 24 in. Folding Tool
https://amzn.to/3JG0U1V

Stanley Fat Max tape measure
https://amzn.to/42p7Qb5

Red snips
https://amzn.to/3V99mZI

Malco M14N 14-inch Straight Cut Aluminum Snip
https://amzn.to/42dFAbi

Malco 3" Hand Seamer
https://amzn.to/42dFAbi

Malco 6" Hand Seamer
https://amzn.to/3YKMH88

IDEWALT 12V MAX Cordless Screwdriver, 1/4-Inch Hex Chuck, 1-Inch Bit Tips, Electric (DCF610S2) *NOTE this is a low power drill for sheet metal only (works great to get in tight places but has low tourqe). Get a 24 volt impact is this will be our primary drill.
https://amzn.to/3LpOCMo

As an Amazon Associate I earn from qualifying purchases.