Razor Ground Force tire swap

After a lot of research on how to retrofit bigger tires on the Razor Ground Force, I came up with this setup. All the info from the sprocket to the clutch and bigger tires is below. I’m not much of a tech wiz so I copied the descriptions of my parts.

T8F 8mm 44T Sprocket Chain Drive with Axle Axle Shaft Hub Free Wheel Adapter
shaft 1/2 5/8, 3/4, 13/16, 7/8, 1, 1-1/16, 1-1/8, 1 1/4

NEW GO CART MINI BIKE 56" BRAKE THROTTLE CABLE BARREL & BALL ENDS SMOOTH ACTION

Transmission Gear Reduction Box Clutch Replacement for 47cc 49cc 2-stroke T8F 11T 13T 14T 17T 20T Teeth Pocket Mini Bike Silver

HIAORS T8F Sprocket Chain With Spare Master Link for 2 Stroke 47cc 49cc Chinese Mini ATV Dirt Quad Pocket Bike Minimoto Parts

Gekufa Go Kart Sprocket Hub with 3/4" Bore & 3/16" Keyway Fit for Go-Karts and Mini Bikes, Sprocket and Drum Mounting Hub (Hardware Included)

Uxcell a16041400ux0830 Round Rod Coupling Nut M10 Female Thread Rod bar Stud Metal Round Coupling Connector Nuts 10 Pcs

Regarding the rod bar, I had to screw these to the axle. It’s just a coupling and then take a cut bolt and screw that in and the nut will screw tight into that.

With the sprocket hub, get longer bolts and crank down evenly on it so the wheel sits straight. It’s a two piece harbor freight 8” wheel.

The cable will be larger diameter than what the throttle is for the engine. Just customize it as you wish. As far as the throttle, I’m using a thumb throttle control, haven’t got that far so hope it works smooth.

Any questions let me know. Thanks