Скачать или смотреть AutoSlide: How to Replace your Push Button Batteries

This is an instructional video on swapping out the CR2016 batteries in your Push Button.
Please note:

Be extremely careful when removing the motherboard. It is safest to pry it out from underneath the board, as demonstrated in the video.

Note that it is easier to pry off the push button motherboard by applying leverage to the underside of the board (example: underneath the printed word "AUTOSLIDE" on the end opposite the screw).

Make sure that all points of the motherboard are secured (popped back into place) before replacing the cover to resume operation of your push button.

We do not provide spare springs if they fall out of your standard push button. You may be able to use springs in pens in its place - otherwise, we recommend ordering a replacement.

If the blue light on your AutoSlide Push Button dulls or disappears completely, we recommend replacing the batteries.

---------------

The switch in the elite push buttons (demonstrated in the first half of the video) has the settings "M", "S", and "P". "M" will allow the push button to open the door with the unit in the two main modes (Green and Orange).

M will enable it in only Green and Orange Mode for Standard units and Green, Blue (if toggle is enabled), Red, and Orange Mode for Elite units.
S will enable it in only Green and Orange Mode for all units.
P will enable it in only Orange Mode for all units. Be sure to program Pet Mode first.