Скачать или смотреть NRG SHORT HUB (srk-131h) Horn and srs wiring quick tutorial 2004-2008 tsx

It’s not as “in depth” as I would have hoped for but I’m camera shy so what don’t judge me. Any what I fail to mention verbally I’ll do via text…..

Ok so this is for the nrg SRK-131h shirt hub on my 2005 tsx.
1st and foremost I hope you like wiring well it’s actually not that bad I’m just be dramatic, once you’ve made it past the factory steering removal this is what’s next.

The provided wiring in the kit you get
2x resistors
1x red wire
1x white wire ( didn’t apply to mine…I hope ) 🤷‍♂️

The wire has the “female” end that would connect with the positive for the horn however I noticed it was a tad touchy and easily came off soooo I went the extra mile and reused the factory steering wheel harness connector.
De-pinned all the other wire’s except the green / yellow. Solder the red to the green/yellow heat shrink and bam 1 down that much closer to a pat on the back.
Next up the air bag, the resistors provided came with female pins ready to go. I de-pinned the srs connector connected the wires and then heated up some shrink to seal the deal.
Now if for some reason you wires don’t match the colors I have just follow yellow to yellow, than red to red on the actual airbag side.
My horn did require the usage of a small adapter harness that momo provided with my wheel.

Once everything is all back together you should be good to go! Beep-beep!! Hopefully… 🤞

Now engage in that well deserved pay on the back.