EcoTech Vectra Disassembly and Reassembly (S1,S2,M1,M2,L1,L2)

EcoTech Vectra Disassembly and Reassembly (S1,S2,M1,M2,L1,L2)
This is for component replacement, maintenance cleaning) and general inspection

Remove Quick Couples (&)Inspect
Inspect Orings
Remove Volute (Requires Allen Key) (&) Inspect
Large Oring remove, clean and inspect
Remove Propellor Assembly (&) Inspect
-Clean
-Check Blades
-Check Magnet
-Check Impellor Clip (It is not necessary to remove this clip to clean or inspect the impellor)
Check Motor Assembly Clean if necessary
Check Bearing and makes sure it is seated properly. Bearing is direction-specific - make note of direction.


Thank you for watching: Don't Forget to Subscribe!
http://www.youtube.com/c/EcoTechMarin...

Please remember that EcoTech does not regularly monitor forums or social media feedback but we are always available and always happy to hear from you. For comments and/or assistance please contact a representative directly at: [email protected] or by calling 1-800-785-0338 Ext. 2. Chat support is also available through https://support.ecotechmarine.com/hc/... Service hours are 9AM-5PM EST M-F.