Cutter Compensation on Siemens 808D ADV with Fusion 360

In this video, I use contour toolpaths generated by Fusion 360 to test how to adjust Wear on the Siemens 808D ADV controller. I posted and explored the four posts offered in Fusion: In Computer, In Control, Wear, and Inverse Wear.

Verdict:
1) In Computer works well for adjusting for wear. In the video, I changed the diameter of the tool, but setting a negative offset would also work.

2) In Control worked well for me. I was able to add a negative value as an Absolute Wear value and the tool path ran fine.

3) Wear did not work for me and the machine gave me a collision error. This may have been because I had the radius saved in the controller, but I'm not sure at the filming of this video.

00:00 - Start
00:09 - Introduction
00:55 - In Computer in Fusion 360 Explained
01:24 - Running Wear using Fusion 360
08:29 - In Control vs Wear vs Inverswear
12:22 - Running Wear: FAIL
13:41 - Success using In Control!
17:01 - Conclusion