Скачать или смотреть RHCSA RHEL 8 - Configure firewall settings using firewall-cmd/firewalld

Your support on Ko-Fi is much appreciated:
👉 https://ko-fi.com/csg_yt

Join our new discord channel:
👉   / discord  

Buy CSG Merchandise:
👉 http://tee.pub/lic/csg

This video is based on RHEL 8.

Video to cover the section 'Configure firewall settings using firewall-cmd/firewalld' for the RHCSA (Red Hat Certified System Administrator).

More information on the required learning: http://bit.ly/rhcsa8

Notes from the video:

The local firewall on the server is managed by the firewall-cmd command line, the first area to learn is about zoning on the firewall.

This has been covered largely in a previous video though some sections will be revisited.

Note in the exam you may be asked to enable IP forwarding this essentially allows the server to route packets to do this you need to enable it in the sysctl file:

vi /etc/sysctl.conf

Add the following line:

net.ipv4.ip_forward=1

Then to ask sysctl to re-read the config:

sysctl -p

I will mostly go over the same using the GUI, to launch to GUI run:

firewall-config

Note, this won’t be installed by default, to install run:

dnf install firewall-config

To get the current state of the firewall run:

firewall-cmd --state

To list all of the zones run:

firewall-cmd --get-zones

To see what is configured in a particular zone:

firewall-cmd --zone servers --list-all

To view the zones currently assigned to each interface, use the –get-active-zones option:

firewall-cmd --get-active-zones

To get the current config of a particular zone:

firewall-cmd --zone servers --list-all


#rhcsa #rhel #linux #redhat