How to fix a broken plastique part (car bumper) using HG Power Glue DIY

device:

HG Power Glue https://amzn.to/3ONZx37

ADHESIVE:
Remove the upper section of thesealingcap (threaded). Do not cut off the tip of the adhesive!
Important Ensure the tip of the adhesive does not become dirty and contaminated.
Tip: Wipe off adhesive residue after use on a blank sheet of paper.
The red dot on the tip has no functions.

GRANULATE:
Remove the yellow lid (threaded) and carefully cut off the very top section of the tip

Reproducing broken-off, small parts

1. PREPARATION / PRETREATMENT
2. GRANULATE:Spread the granulate directly onto the area where the new holder is required. The height of the granulate should not be more than 2 mm Please note: The more granulate that is placed on the base material, the more stable the new holder will be.
3. ADHESIVE: Drip the adhesive on to the granulate until all the granulate is completely saturated with adhesive. Warning: adhesive reacts immediately with granulate.
4. HARDENING:After just a few seconds, you are already able to file or sand the hardened material to shape it into the form required.

Filling holes / missing material

1. FORMWORK: In order to prevent the granular trickling through, you can mask off the open sides with masking tape.
2. GRANULATE: Now trickle the granulate into the hole/crack to be filled (No higher than 2 mm)
3. ADHESIVE: Drip the adhesive onto the granulate until all the granulate is completely saturated with adhesive Warning: adhesive reacts
immediately with granulate Chemical reaction occurs and heat is created. Repeat this process (applying powder and saturating with adhesive) until the desired filling height has been achieved.
4 HARDENING: Depending on the filling height, the masking tape can be removed after approximately 2 -10 minutes and the material can be worked on. Sanding, drilling, thread cutting, painting etc.

Adhesion: (without adding granulate)

1 PREPARATION / PRETREATMENT (see above)
2 DOSING Apply adhesive thinly on one side of the part to be glued
3 CONTACT PRESSURE: The adhesive remains viscous until hardening process is started by contact pressure. Adjustment is possible for a short time without pressure.
4.DRYING: In order to achieve maximum adhesive power we recommend leaving the adhesive for a few minutes without applying pressure. Several hours may be needed for hardening of porous surfaces such as porcelain, metal, stone, tiles etc. (maximum of 24 hours). The HG-Activator will help you to bond such materials together within seconds. The final rigidity may vary depending on the material

__________________________________________________________________________________________

Thank you for watching my videos!

I'd really appreciate it if you subscribed to my channel or if you leave a positive feedback.


My social media links:

Instagram:   / pduesp  

Facebook:   / sascha.pduesp.9  

Twitter:   / pduesp  


All products shown in my videos have been purchased by myself. (In case of exceptions they will be marked as such)

Everything I say and suggest is my own opinion, and of course if you decide to follow my advice then please take care of your own safety.

I might post affiliate links in the description for products and tools that I use regularly. If you use these links to purchase your own products you can support me and my channel, helping me to produce more content. (You will incur no extra charges for using these links, they remain the same price as before)

Sincerely yours,


pduesp