DIY 30 Ton Hydraulic Forge Press Part 3

Описание к видео DIY 30 Ton Hydraulic Forge Press Part 3

In this final installment, I assemble the press, do some troubleshooting, and put it through its paces.

Red Beard Ops -    / @redbeardops  

Tyrell Knifeworks -    / @tyrellknifeworks  

Hydraulic Cylinder - https://northernhydraulics.net/catalo...

SAE 12 x 1/2" NPT 90 Degree Fittings (Need to purchase 2) - https://www.surpluscenter.com/Hydraul...

Prince Hydraulic Directional Valve - https://www.surpluscenter.com/Hydraul...
NOTE -
* YOU MUST HAVE A PRESSURE GUAGE INSTALLED IN ORDER TO ADJUST PRESSURE*
- TO ADJUST PRESSURE - Turn Adjustment Screw CLOCKWISE to INCREASE Pressure / Turn COUNTER-CLOCKWISE to DECREASE Pressure
- Route Port A of Valve to Top Port on Cylinder, and Port B of Valve to Bottom Port on Cylinder in order to have the ram engage when toe on foot pedal is pressed down. The handle will engage the ram when pressed toward ceiling, and will retract the ram when handle is pulled down.

Oil Filter - LENZ Spin-On Filters Assembly CP-750-10P: 10 Filter Micron, 100 PSI, 20 GPM, 3/4” NPTF Port, 15 PSI Bypass, No Indicator Ports, 221005 https://a.co/d/ivTX2yh

Coupler Set - 1/2" to 5/8" L075 Flexible 3-Piece L-Jaw Coupling Coupler Set & Rubber Spider https://a.co/d/fz2IJT8

Pump - Bestauto Hydraulic Wood Splitter Pump 3000 PSI 2 Stage Log Splitter Pump 13 GPM, Hydraulic Gear Pump 3600 RPM Aluminum Log Splitter Pumps 1/8" Keyed Shaft for Gas Log Splitters/Hydraulic Power Units https://a.co/d/3gUGqKB

Reservoir - https://www.northerntool.com/products...

Reservoir Strainer - Buyers Products SW2001253 Thru-Wall Sump Strainer (Strainer Thru-Wall 2In X 1 1/4In) https://a.co/d/d5vCRVs

3/4" Return Line Hose - Apache 98398374 3/4" x 36" 2-Wire Hydraulic Hose Male x Male Assembly https://a.co/d/6twucZ2

1" Suction Hose - Apache 98392250 1" x 5' Low Pressure Hydraulic Return Line Hose with Worm Gear Clamps https://a.co/d/2EHXwoB

5hp Motor - https://www.ebay.com/itm/5-HP-SPL-345...

Thanks again for hanging out with me during this build. I really appreciate everyone who has taken the time to show some interest.

Комментарии

Информация по комментариям в разработке