Audi 2.7T Intake Manifold / Valve Covers Powder Coated

Powder Coating Procedure

- Strip parts of excess fasteners etc
- Degrease and clean
- File down casting parting lines
- Oven preheat cycle for cast Aluminum - 420C for ~20 minutes
- Light sand (~120 grit) to smooth surfaces
- Degrease and clean… again
- Mask threaded holes and gasket / o-ring surfaces
- Shoot the powder
- Oven cure - Temp/Time depends on powder used
- Cool parts
- Remove making
- Enjoy

More info on my 2001 Audi S4 project:

Audizine build thread:
https://www.audizine.com/forum/showth...

Audi 2.7T Oil Pan / Pump / RMS / Front Crank Seal - Installation
   • Audi 2.7T Oil Pan / Pump / RMS / Fron...  

Oil Check Valves / Distribution Tube Servicing - 2.7T Audi
   • Oil Check Valves / Distribution Tube ...  

Maxspeeding vs Audi OEM Rods - Balancing - Are the MS Rods balanced out of the box?
   • Maxspeeding vs Audi OEM Rods - Balanc...  

Audi B5 S4 A4 Rear Control Arm Rebuild - Bushing Removal / Install and Powder Coating
   • Audi B5 S4 A4 Rear Control Arm Rebuil...  

Audi B5 S4 A4 Rear Diff Refresh - Powder Coat and Output Seals
   • Audi B5 S4 A4 Rear Diff Refresh - Pow...  

Audi B5 S4 Stage 3 K04 $10k+ Parts Haul - PB Garage 2.7T Build-Off Challenge
   • Audi B5 S4 Stage 3 K04 $10k+ Parts Ha...  

Audi B5 S4 2.7T K04 Engine Assembly
   • Audi B5 S4 2.7T K04 Engine Assembly -...  

B5 2.7T 01E K04 Engine Pull and Build Specs:
   • B5 2.7T 01E K04 Engine Pull and Build...  


Zombie Rock by Audionautix is licensed under a Creative Commons Attribution 4.0 license. https://creativecommons.org/licenses/...
Artist: http://audionautix.com/