Winding a DIY Sustainer Driver

DIY Sustainers are a project where there has been relatively little development beyond the most simple of circuits paired with a coil of wire around a magnet. I set out to create a better DIY sustainer by doing what any reasonable person does: I bought a commercial system and reverse engineered it. This driver design is the same construction but with more commonly available materials to make it easier for the DIY community to undertake. A full material list and specifications can be found here: https://scientificguitarist.wixsite.c...

For a full rundown of reverse engineering the commercial system, go here: https://scientificguitarist.wixsite.c...

This driver design works best with a circuit like the Sustainiac, as found in the link above, or with my Fermata sustainer circuit, which you can find here: https://scientificguitarist.wixsite.c...

00:00 - Intro
02:13 - Kit Contents Overview
04:15 - Mounting Magnets to PCB
06:11 - Winding the Coils
12:30 - Wiring the Driver
24:55 - IMPORTANT NOTE!
25:10 - Final Assembly