Trico Maxx Pinch Tab Wiper Blade Installation

- Before installation, remove the plastic protector from the blade rubber.
- With this arm type, it is necessary to remove the pre-attached adaptor on the wiper blade, and replace it as follows, with adaptor “BC”:
- Identify the release tabs on the pre-attached adaptor.
- Using your index fingernails, pull both release tabs toward you.
- The pre-attached adaptor will tilt toward you and disengage from the blade. Discard it.
- Locate adaptor “BC” and position it so that the release tabs face up. Tilt adaptor “BC” back into the cavity in the blade until it “clicks” in place.
- Both release tabs must lock onto the blade before proceeding to the next step.
- Press the tab on the front of adaptor “B”.
- Lift shim “C” off of adaptor “B” and discard it.
- Hold your thumb firmly on the front of the adaptor raising the back end up.
- Align the side arm tabs with the side tabs on the back end of the adaptor and raise the blade into the underside of the arm.
- Rotate the blade up until the tip of the arm locks underneath the adaptor tab.
- The adaptor must lock into the wiper arm where indicated.
- Before use, be sure the wiper blade is locked onto the wiper arm.