How to use Product Interface & wave Interface Linker in NX 10.0 ?

This is the Video series on modeling commands in NX 10.0.
Inthis video i have explained about the Product Interface And Wave Interfce Linker.
In previous videos i have explained some other modeling commands if you have not seen that videos pl click on below links-
Intro of nx
   • Introduction Of NX 10.0 (Basic tutori...  
Lect.-1
   • How draw a sketch in NX 10.0 ?  
Lect.-2
   • How to make a model with NX 10.0 ?  
Lect.-3
   • All about Edge Blend command in NX 10.0?  
Lect.-4
   • (Continue).... All about Edge Blend i...  
Lect.-5
   • Pocket & Pad command in NX 10.0  
Lect.-6
   • How to apply Emboss & Offset emboss i...  
Lect.-7
   • Видео  
Lect.-8
   • How to make duplicate body in NX 10.0  
Lect.-9
   • How to use promote body command in NX  
Lect.-10
   • How to use Isolate object of feature ...  
Lect.-11
   • How to use emboss body command in NX ...  
Lect.-12
   • How to use assembly cut command in NX ?  
Lect.-13
   • How to use SEW command in solid in NX...