Скачать или смотреть 15) Finitura delle fasce parte prima

Indice dei video : http://davidesora.altervista.org/vide...

ENGLISH TRANSLATION of the written notes in the video, in order of appearance :

00:06 - Finishing of the ribs - part one

00:16 - After gluing the linings, plane the protruding part bringing it almost level to the ribs

00:35 - Be careful to only lower the linings, without going to affect the ribs not to change the heights

01:10 - Be careful not to touch the blocks, which at this point still present a glossy surface due to the glue with which they were impregnated previously

01:30 - Finish the leveling of linings on sandpaper plane respecting the inclinations of the top and back side, continuing until both ribs and blocks will be slightly but evenly flattened from sandpaper

02:04 - The gloss of the glue layer will have to disappear completely from the blocks, leaving a uniformly matte surface with the linings perfectly level with ribs and blocks

02:22 - Check planes and inclinations on the glass plane

02:34 - Tilt of 0.5 mm for back plate side

03:31 - Tilt of 1.5 mm for top plate side

03:40 - Measure the final heights of the ribs, in this case 29.5 mm at the upper block, 31.7 mm at corner block tips, 31.7 mm scarce at lower block

04:10 - Using a sponge wet the ribs with water to swell the wood and all the marks and scratches on the surface

05:02 - Allow to dry for at least two hours or longer, making sure that the surfaces are perfectly dry before beginning the finishing with scrapers, to prevent fraying the wood fibers

05:15 - Use straight scrapers sharpened at 90°(with double cutting edge)

05:52 - Work in a longitudinal direction holding the scraper parallel to the flames, eliminating all the concavities and irregularities to obtain a slightly convex surface in the transverse direction


Index of videos : http://davidesora.altervista.org/vide...
.