TRICO Flex Blade Pinch Tab Arm

- If there is a plastic protector on the blade rubber, remove it before installation.
- With this arm type, it is necessary to remove the pre-attached adaptor on the wiper blade, and replace it as follows, with adaptor “BC”:
- Push the small adaptor lever toward the center of the blade.
- While doing Step 1, lift the factory installed adaptor off of the blade and discard it.
- Find adaptor “BC” and press it onto the center of the blade. The two nubs inside of the adaptor lock onto the area on the blade marked “X”.
- Press the tab on the front of adaptor “B”.
- Lift shim “C” off of adaptor “B” and discard it.
- Hold your thumb firmly on the front of the adaptor raising the back end up.
- Align the side arm tabs with the side tabs on the back end of the adaptor and raise the blade into the underside of the arm.
- Rotate the blade up until the tip of the arm locks underneath the adaptor tab.
- The adaptor must lock into the wiper arm where indicated.
- Before use, be sure the wiper blade is locked onto the wiper arm.