Скачать или смотреть Невероятный процесс: Искусство реставрации ножей: Наследие 101 лет

Restoration and restore of a 100 year old rusty cleaver knifer. The knife was very badly rusted. It had many dents and scratches. My goal with this restoration project was not to overwork the surface of the knife. It was not an easy restoration project.
=============================
Social Media:
My Instagram:   / mw_restoration  
My Facebook:   / mwresto  
=============================
First thing I did was remove the old handle. Since the cleaver was very badly rusted, it was completely sandblasted. There was still rust in the pores of the surface that could not be removed with sandblasting. That's why I treated the cleaver with electrolysis. The scabbard had a lot of dents and quirks. That's why I sanded the entire sheath. The surface was finished with a steel brush. This made the surface shiny again. All edges of the knife were ground with an arrow and sandpaper. All surfaces have been polished to a high gloss. Finally, the cutting edge was ground. The first part of the project was finished. I used oak board for the wooden handle. I cut the oak board into small slices. I always put a small aluminum plate between the individual discs. It was all glued together afterwards. The knife handle was then ground and adjusted. Finally there was the wedding. The knife handle and the knife were glued together. The result is unique. The knife is very sharp. It's a lot of fun to cut with it. If you liked the video, then read a comment and like it.

Amazon Links
Kärcher WD5 vacuum cleaner: https://amzn.to/3Rf3ttB
Sandblasting booth: https://amzn.to/3AofFSN
Blasting material: https://amzn.to/3nvW3UV
Laboratory power supply: https://amzn.to/3OA4FWz
Wera: https://amzn.to/3AiPPiH

00:00 Cleaver Restoration/Restore
00:17 Disassemble handle
00:39 Remove rust from knives
00:53 Sandblasting
01:25 Inspect the Cleaver
01:45 Electrolysis Setup
01:56 Set up and start electrolysis
03:05 result after electrolysis
03:21 Gsaw off cleaver knife handle
03:32 Grinding a cleaver knife
04:38 Grinding cleaver knife blade
05:17 Finish the surface with a steel brush
05:43 Grind knife bevel
06:10 Cleaver polishing
06:52 Clean Cleaver
07:16 Sharpen knife edge
09:10 Create a new knife handle from oak
09:31 Cut oak board
10:05 Cutting aluminum plate
11:00 Assemble aluminum plate and oak board
11:57 Glue knife handle
13:03 Sharpen knife handle
13:45 Assemble the knife handle and knife
14:40 Show the finished knife
15:04 Test the cleaver knife, cut paper, tomatoes, cucumbers and bread
17:11 Thanks for watching and see you next time