Convert the Krasnogorsk K-3 to Super 16 and Remove the Loop Formers | Lens Re-Centering | Filmboy24

The time is finally here! I've converted my new Krasnogorsk 3 (K-3) 16mm camera to Super-16 and removed those pesky loop formers! In this video, I'm going to show you exactly how I managed to do it.

I did forget to add a couple of photos showing the sanding/polishing of the new gate. It was simply a 1000 then 3000 grit polish.

I know this is a very long video, that wasn't my initial intention but if you know me, you knew it was bound to happen :) Luckily, I've added chapter markers & short titles so it's a bit easier to navigate.

Check out the true 1980's Super-8 Low-Budget Slasher Horror, "Killer", here: https://www.sansperf.com/

Christian's Channel (TrueFilm):    / @truefilm6991  
Rubin's Channel (The Cinematography Lab):    / thecinematographylab  

Affiliate Links:
============
Some of the links in my video descriptions are affiliate links, which means, at no extra cost to you, I will make a small commission if you click them and make a purchase.

Please don't forget to Like, Subscribe & leave me a Comment! Thanks!

----Video Content----

00:00 - Introduction
05:20 - Open the Camera
17:44 - Remove Old Gate
21:04 - Install New Gate
24:05 - Remove Loop Formers
27:30 - Replace Seal & Tape Holes
37:50 - Replace Drive Gear
40:05 - Re-Assemble Camera
46:38 - Install Lens Ring
51:09 - Back to Mike
57:00 - Final Film
59:29 - Conclusion

#ConvertKrasnogorsk3 #Super16 #Super16mm #RemoveLoopFormers #16mmFilmmaker #16mmFilmmaking #ProcessFilmAtHome #Develop16mmFilm #ProcessMovieFilm #MovieStuffRetroScanUniversal #RetroScanUniversal #LowBudgetHorror #Filmboy24