ETEA Previous Test Solved for Sub-Engineer Civil C and W # 01 | Civil Engineering MCQs

A previous Test of ETEA for the post of civil sub- Engineer C and W department held on 10 November 2019 is solved and explained in details.
This video will definitely help you in preparation for upcoming civil engineering tests.
this will give you an idea about all types of civil engineering tests.

Test include the following MCQs:
1. Minimum pitch of rivet shall not be less than:
2. Bolts are most suitable to carry:
3. The viscosity of gas:
4. Which of the following object gives circular section, when it is cut completely by a section plane (irrespective of the angles of the section plane):
5. Hidden lines are drawn as:
6. The included angle of hexagon is:
7. In orthographic projection, the rays are assumed to be :
8. An angle can be set off and measured with the help of:
9. Transverse slope given to road cross section for surface water removal is known as:
10. The degree of saturation for the moist soil is:
11. The unconfined compressive strength of very soft clay is:
12. The plastic limit of soil is defined as the:
13. The point at which the whole mass of the structure acts is called :
14. The point at which the whole weight of the structure acts is called :
15. Brinell’s test is used for :
16. A beam is attached with three fixed supports. What will be the degree indeterminacy:
17. If crushing strength of concrete cylinder is 5345 psi, its tensile strength will be
18. The contact pressure of flexible footing on no-cohesive soil is:
19. In case of lateral loads or moments, the foundation could also be checked to be safe against sliding and over turning. The factor of safety should not be less than:
20. The total load to be arranged for a pile load test in compression should be:
21.Which of the following is deep foundation:
22. The highest point on extrados of arch is called:
23. Surface source of water are:
24. Which is raw sewage:
25. The unit of strain is:
26. Very long columns fails due to:
27. Rough cost estimate is prepared to achieve:
28. Quantity of dry mortar required for 100cft brick work is:
29. Purpose of seal coat is to provide:
30. A water tank constructed at reasonable height from ground level is
31. Unit of electric charge is:
Etea previous Test for Post of sub engineer Civil part 02
   • Etea previous Test for Post of sub en...  

KPPSC Previous test for post of Civil Engineer #01
   • Civil engineering previous test solve...  

KPPSC Previous test for post of Civil Engineer #02
   • Civil Engineering Previous TEST # 02 ...  

#Eteacivilengineeringprevioustest #EteaCivilengineering #civilengineeringprevioustest