Скачать или смотреть Suzuki B-King LED sequential indicators & DRL side lights. Read description below for how too guide.

A quick video on how fit DRL’s and sequential indicators to your B-King.

I bought a ‘30cm sequential LED switchback DRL’ kit from a popular auction site. They come as a pair so only order 1.

When LED’s arrive at the end of the strip there is a square rubber stopper, pull it off. Also there is double sided tape fitted to it. Remove the tape as it covers the LED’s and will stop you sliding the LED down into the housing.

Push the LED strip in through the indicator hole and push it as far down as it will go (see pics in video). Once it’s pushed all the way in you should get the whole strip in the housing by bending the end inside with the wires.

To get the wires out so you can connect them, you can either leave the original indicator out totally, or cut a small notch for the wire to pass under the original bulb holder and the side (again see pics). I use the standard indicator as well as the LED strip on my bike.

Wiring is dead easy.

Yellow goes to black wire (+) on indicator bulb holder

Black goes to black (—) with white trace on indicator bulb holder.

Red wire goes to an Ignition Live. On the left of the bike as sitting on it there is a single multi plug . On that plug I tapped into the black with yellow trace , although there is a light brown you can use like the other side. On the right side there is a plug with 4 wires, on that plug there is a light brown wire. I used the light brown wire as IGN live.

It really is simple and all in took well under an hour start to finish including soldering and heat shrinking wires etc.

Good luck and enjoy modernising your bike :)