#routerlift

In this new version, placing your Bosch under the plate is practical and fast, it takes less than a minute and your Bosch is ready to use, the same goes for being able to use it again in manual mode, speed and practicality make this version unique.

You don't need to remove the black plate as you can see from the photos, just place your Bosch under the bench and lock it from above with the appropriate screws WITHOUT COUNTER NUT, yes you got it right, screw it from above the bench and you're done.

This version is designed for those who do not have a second milling machine for manual use.

All components are of the highest quality, plate and support are made of 8 mm ground aluminium and linear guides of ground steel.

In this version, the tensioner (red lever) is removed, as resetting it takes 10 seconds. (I have a video about it)

The plate is perfectly coplanar and has been ground by an automatic machining center with centesimal precision and pulled to a mirror finish as seen in the photos.



\\\\ New Reduction Discs //////

Just a small rotation and the disc change is immediate


Specifications:

-Aluminum plate 8mm

-LAP 307x230x8mm (compatible for CMT milling tables)

-Corner radius of curvature 10mm

-4 grub screw M6 for plate alignment on the table

-Screw assembly consisting of ground steel M16 screw.

-M16 nut assembly in 8mm thick aluminum

2 Linear Guide D.12

2 Linear bearings

Centesimal wheel = 26 full turns maximum compression , each turn is 2mm-Reduction disc with 35mm hole in Aluminum NEW VERSION

Various reduction discs in Aluminum available: 13mm -19mm - 41mm - 54mm.