Скачать или смотреть AutoHot | Demand Controlled Recirculation Systems | Wireless Pairing Instructions

In this video we will show you how to pair the Wireless Push Button Activator and the Wireless Motion Sensor to the AutoHot On Demand Controller.

On the controller, press and hold the soft, small button down for three seconds until the LED light blinks rapidly; this means it's in pairing mode.

While in pairing mode, press and hold the Push Button Activator.

For the motion sensor, repeat the same steps. Press and hold the soft, small button down for three seconds until the LED light blinks rapidly, take your motion sensor and turn the on switch located on the side. You will see a blue flash and you have successfully paired.

You can connect up to ten push buttons or motion sensors per controller.

The detecting range for the wireless push button activator is 1,000 feet in open air, which is the absolute best in the industry. The push button activator comes standard in our residential kits.

The Wireless Motion Sensor activates the Recirculation Pump whenever it is triggered by motion and the hot water line sensor is below its target temperature. The detecting range is 600 feet in open air.

You can purchase the Wireless Push Button Activator and Motion Sensor, from our website www.AutoHotUSA.com or find a local sales representative in your area, which is also listed on our website.

For more information on the AutoHot On Demand Systems and activators, which have been awarded the most Energy Efficient recirculation systems in the market, please reach out direct: [email protected]