How to Install SuperATV's Low Profile Fender Flares for the Can-Am Commander XT

Braden is going to walk you through how easy it is to get our fender flares installed. Leave the dirt behind rather than smearing it all over your Can-Am Commander and, ultimately, on you. SuperATV’s Low Profile Fender Flares keeps the dirt off your neck and debris out of your cab. It extends your stock fender flares by up to 3.75”. All that extra protection leaves your machine cleaner and looking more badass than before. Made in the USA!

00:35 – Tool list
00:39 – Line up front fender flare and mark the holes for drilling
01:35 – Drill holes in fender
01:46 – Install lower pushpins into front fender flare
02:12 – Mark upper hole in front fender flare
02:28 – Drill upper hole in front fender flare
02:48 – Install upper pushpins into front fender flare
02:59 – Drill the rest of the holes in front fender flare
03:21 – Install hardware into front fender flare
04:38 – Fully tighten hardware in front fender flare
05:21 – Remove factory hardware from back fender
05:54 – Use pushpin to start install of back fender flare
06:14 – Thread hardware for the back fender flare
06:56 – Fully tighten hardware on front fender flare

Ready to get your fender flares? Visit superatv.com...
https://www.superatv.com/can-am-comma...