Kunstwerk Kia Stinger 3.3, 2.0 Catback EVC Exhaust Install

A quick video on the Kunstwerk 3.3 EVC Catback Install. This applies for both 2.0 and 3.3 Models.
Steps:
1.)Install Midpipe(with Supplied Bolts)
2.)Install Both Catbacks(With Supplied Bolts)
[Following steps are for Racing versions Only]
3.)Place Receiver in Rear Battery Compartment
4.) Route both evc cables from the bottom of the car to the rear battery compartment via the Rubber grommet located in front of the battery compartment.
5.) Plug in both evc cables to the two middle connectors on the receiver.
6.) Screw in the antenna on the right connector.
7.) Connect the final Power cable(Cigarette Lighter) to the receiver and cut off the cigarette connector.
8.) Splice the wires and crimp them to metal rings(one positive and one ground)
9.) Route the ground the the bolt on the right hand of the battery compartment and bolt it down
10.) Route the positive wire to the Plastic compartment and do the same on the positive bolt in the center.
11.) Ensure your transmitter is on and test with your remote.