Скачать или смотреть etrailer | GloLight LED Trailer Tail Light Review

Click for more info and reviews of this Optronics Trailer Lights:
https://www.etrailer.com/Trailer-Ligh...
Check out some similar Trailer Lights options:
https://www.etrailer.com/dept-pg-Trai...

https://www.etrailer.com
Don’t forget to subscribe!
   / etrailertv  

Full transcript: https://www.etrailer.com/tv-review-op...
Today, we're going to be taking a look at and showing you how to install the GloLight LED trailer tail light with the clear lens.What sets this light apart from many of the others is its running light. As you can see, it has that circular halo design, and puts out a pretty good amount of light. Now, when you hit the brake lights, it really makes a difference in how bright it is, to let others know that you're applying the brakes. Same thing with the blinker. As you can tell, it's nice and bright.Another thing that separates this light from many of the others is its clear lens. In my opinion, when the light's not in use, it just gives off a little more of a clean look.

The light is going to have 21 diodes. Its power draw at 12.8 volts, to run the tail light, it's going to take .145 amps; and for your stop and turn, it's only going to use .375 amps. Now that's good, because it'll give you plenty of power to run all your other lights that you might have.This light is sonically sealed, which means it is submersible, however I don't recommend submersing it for any length of time or when you have power to the light.One thing I really like about this light is that it's LED, which that means it's going to be a lot stronger, brighter, and last a lot longer than your traditional style incandescent light, which means it'll be a great replacement or even an upgrade for it.Here on the backside of the light, you can see we have our three connection points. They are going to come covered in dielectric grease, so you don't have to worry about that during your install. Each one actually has a description of what each contact point does.I'll show you just how easy it is to get our light installed.

Just take our connector, feed it through the hole. Just plug it in. Sometimes these lights can be a really tight fit, so if you need to use some silicone spray or even some soapy water to help assist you getting it in, you can do that. Start at the top, put it in first. You'll feel it seat all the way down into the grommet.

It's just that easy. All right, now we'll go ahead and put some power to the light, and make sure it works. If you bought more than one of these lights, you go ahead and repeat the same process on the other side.That'll do it for our look at and installation of the GloLight LED trailer tail light with the clear lens.