Скачать или смотреть Waste Oil Burner SUPER HOT LEAN BURN Flame Nozzle # 3

This video contains Paid links that gives me a 6% commission if you click and buy any product on that website . Check out my store front https://www.amazon.com/shop/nobox7
Support this channel on Patreon https://www.patreon.com/user?u=3620781 Amazing test today , learned 2 very important things , first atomization is more important then i thought for lean burns also learned exactly how to build a good atomizer
TypicaL 40k watt waste oil burners use about 4 liters of waste per
hour I have built units that use up to 2 gallons per hour or about
145,000 watts I use oil burners for many things mostly for burning
tree stumps out of the ground, waste oil burners work great for
forges or smelting metal. Ive built many types of waste oil burners
from syphon nozzle waste oil burners to drip feed to vaporizer
coil waste oil burners . these also can be used to build a furnace
and heat very large areas . the most efficiant waste oil burner
i have biult is a siphon nozzle
atomizer and it uses about 4 liters of waste oil per hour .
do not burn transmission oil it is toxic .Oil Burner Designs
Drip Style
Low Tech. No atomization.
Natural Draft possible (no electricity)
Mother Earth News’ design is widely used. Designed in 1970’s.
Today’s motor oil has additives that resist degradation and allow engines to run
at higher temperatures. In effect, waste oils are now much harder to burn cleanly
and likely require preheating and atomization.
Conventional fuel oil burners
Modest efficiency improvements over time - although overall burner design hasn’t
changed much
As homeowners upgrade to modern heat pumps, these old style burners are
ubiquitous in scrapyards and can be purchased for very little cost.
Most can be operated without modification with up to 20% biodiesel. (B20)
Predictable issues with higher ratios of biofuels - ‘gelling’ and damage to rubber
seals. Commercial biofuel safe pumps and preheaters available.
Very convenient, tight design.
Siphon Nozzle
Requires high capacity air compressors
LP can be used in lieu of air
Fuel pumps not required
Preheating for reliable viscosity
“Constant level device” to maintain consistent fuel flow
Simple DIY nozzles can be made from off the shelf hardware
Manufactured nozzles available for retrofitting gun style burners for Waste Oils
Babington Style
Fuel flows OVER nozzle, rather than through nozzle
Imagine fine mist from a whale’s blowhole
Filtration matches your pump - not your nozzle
Requires sump and pump
Same preheating issues with alternative fuels