Rear Wheel Bearing Hub Assembly Replacement - Mitsubishi Pajero Gen 4

Rear wheel bearing hub assembly replacement on a 2007 Mitsubishi Pajero (Montero / Shogun) Gen 4 NS.

The procedure would be similar to other 4WD vehicles with IRS setup.

Includes explanation of different methods to remove the bearing hub assembly from the vehicle.

Sliding hammer is an optional tool for the job.

Service specifications:
ABS sensor & rotor guard bolts: 11 ± 2 Nm
Axle hub nut: 220 ± 10 Nm
Brake calipre bolts: 115 ± 10 Nm
Hub assembly bolts (vehicles with 16 inch brake): 77 ± 8 Nm
Hub assembly bolts (vehicles with 17 inch brake): 135 ± 15 Nm
Rear shocker lower bolt (tighten on level ground): 100 ± 20 Nm

0:00 Introduction & required tools
1:07 Before starting the job
1:56 How to check the wheel bearing
2:18 Disassembly
4:43 How to remove a seized disc brake rotor
5:23 Removing the handbrake shoes
6:36 Different methods to remove wheel bearing hub
8:27 Removing the wheel bearing hub
12:08 Cleaning and preparing surfaces
13:30 Installing the wheel bearing hub
15:20 Installing the handbrake