Q50 REAL Carbon Fiber Diffuser Installation

You guys know that I don't like Carbon Fiber all that much and if you've been following along, you would know that I have also grown to like the look of the car without a rear diffuser. However, I couldn't pass up on a good deal and snagged an extra diffuser from a subscriber!

Here is a guide to installing a rear diffuser, not only on a Q50, but on any car you can think of. It takes just a bit of prep work and a few key steps and you'll have a diffuser properly secured to your vehicle in no time! Somehow, a couple of key clips were missed when editing this video. I did use 2 small, self-tapping screws on the underside with flared heads to secure the diffuser to the small bumper brackets. No washers necessary thanks to the flared heads of the screws. You also got a glimpse of the painters tape used to hold the diffuser in place for several hours. I used a lot of tape in the corners and in several directions across the top--even more than you saw in this video. Hope this video was helpful!

If you get a second, support the channel by checking out a few of my favorite items in the link below!

My Favorite Things: https://www.amazon.com/shop/speedcult...
Speed Merch: https://teespring.com/stores/speed-cu...