Signal Fire Fiber S06 Cleaver Blade Adjust

S06 Black Optical Fiber Cleaver Of Adjusting cutter angle and Blade Height
(Function: make the cutter edge to cutting the optical fiber so that to solve the problem of the cutter edge became blunt and Cutter edge is not enough high)

Prepare tools: Allen wrench 2mm/2.5mm + Flat Screw Driver
1、use the flat screwdriver loosen the screw a little (not unscrew the screw) of Blade, then use the finger to turn the blade to adjust the angle so that use a new blade edge to cutting optical fiber, then tighten the screw. This step is used for solving the cutter became blunt.
2、use the 2.5mm Allen wrench to loosen 3 screws, there are 2 screws below the cutter and 1 next to the cutter. Then use the 2mm Allen wrench to adjust the cutter height from the video position(next to the cutter, Clockwise for Cutter Up and counterclockwise for Cutter down), what we should do is make the cutter’s upper face is in the same level of the Base for optical fiber holder. Then we tighten the screws.
3、if there is no problem, then we can normally use it.