Скачать или смотреть Asus Tinker Edge T - Change Timezone Tutorial

Tutorial: how to update your timezone on the Asus Tinker Edge T (ATET). By default, it'll most likely have the wrong timezone so here's a quick tutorial on how to adjust the timezone.

Once booted into Mendel Linux, open a weston-terminal, and type in:
timedatectl list-timezones

This will give you the list of available timezones (many of them).

Once you've found your timezone, type in:
sudo timedatectl set-timezone YOUR/TIMEZONE

Then to auto-sync via Network Time Protocol, type in:
sudo timedatectl set-ntp yes

Then reboot with: sudo reboot

And your timezone should be correct.

Asus Tinker Edge T spec sheet:
CPU: Asus Tinker Edge T SoC 1.5GHz Quad Core Cpu (NXP i.MX 8M)
RAM: 1GB LPDDR4
GPU: GC7000 Lite
TPU: Google Edge TPU ML accelerator
Display: HDMI & 22-pin MIPI DSI
Storage: 8GB eMMC, MicroSD slot
Connectivity: RTL8211F-CG Gb LAN, 802.11 a/b/g/n/ac wireless & Bluetooth 4.2
USB: 2x USB 3.2 Gen1 Type-A, USB 3.2 Gen1 Type-C OTG
Camera Interface: 2x 24-pin MIPI CSI-2
1 x 40-pin headers:
up to 28 x GPIO pins
up to 1 x SPI bus
up to 2 x I2C bus
up to 2 x UART
up to 3 x PWM
up to 1 x PCM/I2S
2 x 5V power pins
2 x 3.3V power pins
8 x ground pins
1 x Boot mode switch
1 x 2-pin Reset header
1 x 2-pin DC Fan header
Power: 12~19v DC Power Input Jack (5.5/2.5mm)

The Asus Tinker Edge T is part of the Tinker Board Single Board Computer (SBC) family. However, this board that can perform Computer Vision Artificial Intelligence (AI) and Deep Learning inference (i.e., Image Classification, Object Detection, Segmentation, Pose Estimation) with the same level of performance that you'd find in an expensive desktop computer. It can achieve this because it contains a special chip called an "Edge TPU" (Tensor Processing Unit) that specialises in calculating AI and Deep Learning algorithms which can also be found in a Google Coral Dev Board.
----------
Subscribe to my YouTube channel:
https://www.youtube.com/edgecate?sub_...
----------
#Asus, #TinkerBoard, #TPU