SLO Clone Build Ep.1 - Design and Mounting

In a project I'm calling "The Ultimate SLO Clone" a buddie bought a kit off
Kijiji, and asked me to build it. I go over my thoughts on the Circuit, then hard mount the chassis components.

0:00 - What's Relevant Today ?
1:16 - The Grounding Scheme
2:49 - Using Isolated Jack
4:14 - Mains Grounding
4:58 - The FX Loop Corrections
6:11 - The Depth Knob, Mismatches Documentation
6:37 - Powering LDRs and Switching Matrix
8:23 - FX Loop Routing
8:47 - Channel Switches
10:00 - The Use of Shielded Cables
11:14 - Component Selection
11:25 - Tube Shields
12:12 - Bias Pot
13:28 - Output Transformer
15:37 - Power Transformer
17:57 - But what about 100w ?
18:37 - Fixture Fitting and Hard Mounting
18:45 - Transformer Fitting
20:29 - DC Heater Plan
21:47 - Drilling
22:16 - Chassis Punch
23:30 - Salvaging a Mains Ground Lug
24:43 - Note on Cleaning
25:03 - Inspection and Tightening
25:35 - Ground Point Polishing
26:13 - Note on Mixing Metals
27:17 - Fitting Mains Ground Lug
27:46 - Mounting the Transformer
28:58 - Fitting the Switches
29:49 - Inspecting the Pots
31:12 - Fitting the Isolated Jacks
32:17 - Impedance Switch & Bias Jacks
33:11 - Remounting the Tube Sockets
33:35 - Filler Plates
34:11 - Bias Pot
34:28 - Choke
34:48 - DC Board
35:04 - It's Over !