How to Disassemble Flygt 2800 Series Pumps

This is an informational video on pump disassembly for the Flygt 2800 pump series. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual not included in this video.


In this video, we will walk you through the disassembly process of the Flygt 2800 series pumps.


For more resources and detailed information about the pumps:

https://www.xylem.com/en-us/products-...


Contact us here: https://www.xylem.com/en-us/brands/fl...


Subscribe to our channel for more insights on how our innovative solutions are transforming water and wastewater management.


Disclaimer Warning:

Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way.

All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed.

This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice.

Failure to follow all instructions in the Manual may void the manufacturer's warranty.

If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding.

Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof.


This video has no sound

00:00-00:34 Introduction

00:34-00:48 Remove the Discharge Connection

00:48-01:47 Mount M12 & Lift Pump

01:47-02:06 Place Pump Horizontally

02:06-02:31 Remove the Strainer & Shock Absorbers

02:31-02:47 Remove the Inspection Plug

02:47-03:15 Remove the Lower & Upper Oil Plug

03:15-03:30 Drain the Pump

03:30-03:56 Re-fit the Plugs

03:56-04:07 Remove the Lifting Handle

04:07-04:47 Fit Eyebolt and Lift Pump Upside Down

04:47-05:12 Untighten & Remove Impeller Screw

05:12-05:31 Loosen the Impeller

05:31-05:43 Remove the Suction Cover

05:43-05:54 Remove the Impeller

05:54-06:16 Remove the Diffuser

06:16-06:50 Remove Oil Housing Bottom

06:50-07:07 Remove the Mechanical Seal

07:07-07:34 Remove the Intermediate Piece

07:34-07:59 Lift Out the Rotor Unit

07:59-08:20 Lift and Turn Pump

08:20-08:39 Remove the Junction Box Cover

08:39-08:59 Remove the Terminal Board

08:59-09:12 Disconnect the Stator

09:12-09:40 Remove the Junction Box

09:40-10:07 Remove the Outer Casing


#Flygt #ServiceVideos