TeraFlex SpeedBump install on a Jeep JKU

Since we spend so much time on rough unmaintained roads and trails, figured it was time to step it up a notch and add the TeraFlex SpeedBump & Progressive Bump Stop Kit 1958250 to my Wrangler. This setup mimics the factory bump stop kit Jeep offers on the Gladiator Mohave.

Impressions after first month or so is very positive. It works very well with the Mopar 2" lift kit and Fox shocks. The front speed bumps are audible when front track bar is disconnected (off road under severe flex), but very reasonable and a bit of a warning of how rough it is.

00:00 introduction
01:06 Dismantling front suspension
03:19 Cut jounce tube
05:01 Test fit front SpeedBump
05:53 Check compressed suspension
06:48 Mount jounce tube brace
09:18 RTV on SpeedBump
10:21 Reassemble front suspension
13:10 Flip top rear track bar bolt
15:00 Remove rear bump stop
15:44 Install rear bumpstop cup extension
17:56 Install rear bump stop & spacer
18:48 Torque track bar bolts
19:15 Test drive & first impression