SNS 164 Part 2: Horizontal Boring Mill

Описание к видео SNS 164 Part 2: Horizontal Boring Mill

I use the H.W. Kearns horizontal bowing mill to set up and bore out the center of the two large gearbox stands I recently fabricated. There was a mistake made on some drawings and the incorrect dimensions were given when burned out. Instead of making a mess of them with a torch, or wasting material, I set them up in the mill and bored them out as needed.
In the mix I also show my dads Starrett 2-32" Starrett inside mic, as well as his Starrett 36" vernier calipers, which I use to measure the bore.

Комментарии

Информация по комментариям в разработке

Похожие видео