Installing Impact Collars with Epoxy

How to Bond Impact Collars on Your Arrow Using Two Part Epoxy:

For bowhunters looking to strengthen the end of their arrows for maximum penetration, Iron Will Impact Collars slide over the end of arrows and are meant to be used with or without bonding to the arrow shaft. Depending on the arrow used, there may be a small gap between the collar and arrow shaft. When there is a gap, epoxy works great for filling that gap.

1) Remove any dust or debris from the outside of the arrow using isopropyl alcohol and a cloth.

2) Mix up equal parts of a two part epoxy. Be sure it's mixed thoroughly.

3) Spread the mixed epoxy all the way around the last half inch of the arrow shaft.

4) Slide the Impact Collar onto the arrow, rotating it as you do so, to evenly spread the epoxy around.

5) Screw a field point all the way into your HIT Insert to fully seat the collar onto the shaft.

6) Next, we recommend using an arrow spinner to check that the collar is well centered to the arrow.

7) Finally, leave the arrows upright while the epoxy cures for 24 hours. DO NOT sit them horizontally on a table or the collar could be pushed off center.

Iron Will Impact Collars:
https://ironwilloutfitters.com/produc...

Arrow, HIT Insert, and Impact Collar Epoxy:
https://ironwilloutfitters.com/produc...

Reinforced HIT System
https://ironwilloutfitters.com/pages/...