Скачать или смотреть Husqvarna 565 With 24" inch Bar & Chain Felling Hard Maple, Why I Prefer a 28" Inch Bar

Really part one as the skidding will be the focus on another video . So put this one up more to show the face cut angle & when the hinge lets loose so did a slow mo to highlight that. Point? In "normal" situations without all the root flare to work into, and much smaller face cut angle would have done just fine.

Also Years back I would do these with a 20 inch bar even when the actual diameter with the root flare was past 30 inches. I went to a 28 to actually reduce the cut time as I could usually poke right thru the tree at the back so I had something to poke a bar in to finish the "bore" cut to the right side hinge and only then needed to deal with the trigger wood. So kind of cut more than needed as I re-adjust to the short bar. I put a short segment after the demo tree to show one of the things I used to do to reduce cut time by poking thru from the front to "mark" where the cut was. A strategy to reduce error with matching up cuts and therefore wasting time cutting way more than needed.