Скачать или смотреть PintX to VESC, update 2, UBox failed

So sad, UBox did not make it thru the install process. This is NOT the video I wanted to publish next. I do not think I was being that hard with it on the install. Been messing with electronics for close to 30+ years now. In that time, I have had projects go great and other fail horribly. Most of the time when something goes wrong you know you did something wrong or at least be able to trace back to the issue. But this time I am at a loss as to what happened or how to fix it.

Did I handle it too much? I did move it around a lot trying to get everything in there the way I wanted it. But I was careful and I do not think I knocked anything off. If the UBox is that fragile then maybe it should not be in a skate board that is going to be on trails. 😲

I am hoping I just got a bad box and got lucky it failed before my first ride!

Still got the OG vid files if anyone thinks they see a spot I might have messed, can upload the slowed down vid to verify. If it is something I messed up I want to know what I did, so I don't do it again! I know the VESC community is still small but hoping someone can tell me how I messed up. If it is something I did it happened between 7:25 and 11:35 timestamps.

Not going to give up, still working on a solution. Just wanted to give another update.

I have since removed everything except the switch and battery and still get the same results. I have reflashed to the OG firmware and the momentary firmware and even going back to ver 6.0 I have tried to run the motor wizard many times with many different options, but still getting the error HIGH_OFFSET_CURRENT_SENSOR_2.

From what I can find (which is not much). That error could be just rerun the motor wizard and you are all good or what I am guessing my my case the board is dead.

0:00 BMS
0:28 Fish paper Ava Lights
0:53 Cleaning thermal area
1:35 Screws too long
1:57 Marking up lid
2:40 Start attaching things for real
4:29 Making momentary switch work
6:19 First Green LED this vid
6:30 Hooking up FM battery first time
7:25 Second Green LED this vid
7:35 Installing box connectors
8:40 Rework wiring
9:15 Working on Lid
11:18 Final rework of wires
11:35 Red is DEAD LED 16 Blinks
12:07 Testing foot pad