Скачать или смотреть Installing A Steel Dryer Vent Cap

How would you like to sleep at night with this clanging around outside your house?
I’m going to show you the best way to install a dryer vent cap.
To start with, don’t buy the cheap plastic ones, get one made of steel.
I like to put a magnet in mine, so the flapper doesn’t chatter when it’s windy.
I’m going to cut this 4” dryer duct flush with the wall.
I installed this duct before the masons came, so that I wouldn't have to drill through the brick later.
This vent cap wouldn’t slide in place because of these three prongs, so I cut this section off.
And for all you young guys out there, make sure you wear a face shield when you’re using a grinder- you only get two good eyes.
Once I get it in place and make sure it’s level- I mark the spots where I need to drill four pilot holes.
I’m using three sixteenths of an inch masonry screws- you wanna go easy with these…it doesn’t take a whole lot for them to strip out in the brick.
Finally, I run a bead of silicone across the top and down both sides.
There’s a lot going on at the new house- the guys are hanging drywall on the inside and siding is going up on the outside.
If you enjoy this type of content, make sure to like and subscribe for more. ‪@hausplans‬

#build #howto #construction #diy #contractor #homeimprovement #tools