Throttle Cable Bracket Spring Kit

Video instructions for HZ-2084
Throttle Cable Bracket Spring Kit
Tools you may need:
Adjustable
wrench
5/16” allen
wrench
Screwdriver
1.
Remove driver side rear bolt/nut from carburetor and place bracket between nut and bolt and tighten.
2. Install carb arm bracket with (screw and lock nut) *not provided. Making sure that bracket can rotate freely.
3. Now attach springs (small one on the inside and short side towards firewall) making sure they are hooked
4. Take your supplied 5/16” Allen wrench and tighten lock washer nut until it touches the base of the carburetor
Make sure arm is at 90 degrees out to secure alignment
Next is to lockdown carburetor base bolt and tighten to manufacture specs.

link to part : https://www.cfrperformance.com/search...