Oil pan gasket on BMW E60 N52 engine DIY part 1

Pars and tools you can get here: https://amzn.to/3UOdeDd

This gasket is a common replacement on n52 engine. You should replace this gasket if there is an oil leak or if you are replacing your oil pan.
I also replaced the engine mounts, as I had vibration at idle in a traffic jam.
In this video, you will see how to remove the oil pan. In the second part, you will see how to install the oil pan with a new gasket.

Oil Pan Gasket PN: 11137548031
Oil Pan Bolt Set PN: 11132210959

DISCLAIMER:
All the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All DIY projects entail some risk. It is the sole responsibility of the viewer to assume this risk. I'm is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Some of these are affiliate links, which means I receive a small percentage of sales/commission when you are shopping using my link. Thank you for your support!

0:00 Introduction
0:05 mm socket to loosen up
0:11 Disconnect air mass sensor
0:22 Use T30 Torx bit socket
0:43 mm hex bit socket
0:58 Install tow hook on engine Hook should be in your trunk
1:07 mm socket with drive universal joint and long extension
2:13 Install engine support bar
2:48 Lift the car and remove two front wheels
4:11 mm socket to remove drain plug
4:21 Replace drain plug sealing washer
5:06 Use 10mm socket to loosen
5:27 Disconnect from bracket power steering hose
6:12 Disconnect oil level sensor
6:51 mm socket and 18mm wrench To disconnect control crm
7:07 mm socket and 10mm wrench To disconnect headlight level
7:23 Use 17mm socket to disconnect sway bar links
7:51 mm socket to remove 6 bolts on subframe
8:49 Replace engine mounts (optional)
8:58 Put bungee cord on transmission cooling hoses
9:11 Use E10 socket to remove 3 bolts
9:50 socket to remove all aluminium bolts
11:23 Gasket is dried out and stick to oil pan