Скачать или смотреть How to de-step a Club 420

-Take off mainsheet
-Take boomvang out of centerboard trunk
-Bring boomvang tail to D ring on transom and back to mainsheet bridle pulley and then tie with double half hitch
-Disconnect boomvang from boom (leave on mast)
-Connect top of boomvang to jib halyard
-Disconnect port bungee ring and put ring around jib halyard cleat on mast
-Tension jib halyard and cleat it
-Lower boom with main halyard
-Disconnect main halyard from outhaul
-Tie main halyard together with overhand knot
-Disconnect starboard bungee ring and put ring around main halyard cleat on mast
-Put tail of outhaul through outhaul cleat then wrap outhaul around broom
-Disconnect boom pin and put pin back in mast
-Disconnect topping lift from bungee inside the boat
-Topping lift hook/end of topping lift connected to mast ring
-Disconnect topping lift from centerboard trunk
-Run centerboard topping lift to mast ring and connect to main halyard cleat (or cunningham cleat if too short)
-Disconnect spin halyard from centerboard (leave loose in mast block)
-Disconnect port and starboard side stays (leave roller pins with the side stay)
-Prop mast forward and brace (to not let it fall)
-Disconnect forestay (leave pin/ring ding on bow)
-Take mast out of step (and lay carefully on ground)
-Take spin halyard from block at bottom on mast and go through both lower pins on side stay and tension going through groove at the base of mast
-Continue spin halyard through forestay; tension through same groove pulling all the (forestay and sidestays) tight); cleat spin halyard to jib or main halyard cleat
-Wrap cunningham around mast