2007 R6s Engine Rebuild

After months of hard work, the 2007 Yamaha R6s rebuild finally comes to and end. From spilling fuel to slipping on WD40, an EXTREME amount of effort was put into rebuilding. Lots of coffee and ridiculous amounts of hours from day in to day out during weekdays and weekends, Papa Johns Pizza four times a week on average just so no unnecessary time is spent cooking. Keeping up with school while doing this was a well deserved challenge. The motorcycle had 72,000 miles on it and the engine took a beating and read low compression. So of course, I grabbed a load of tools and ripped everything apart to spec out every component. ENJOY!
Things done:
Valve Replacement
Valves Shimmed
Valves Lapped
Fuel Pump Replaced
Compression Tested
Spark Plugs
Coils
Cylinders Honed Crosshatched at 45 degrees
Oil Seal
Piston Rings
Rod Bolts
Journal Bearings
Carbon Removal
Head Gasket
Valve Cover Gasket
Clutch Disks
Clutch Boss
Clutch Springs
Front and Rear Wheel Bearings
Ignition Switch
All Fluids Flushed
Pirelli Diablo Rosso 2 (Front) 3 (Rear)
RK Chain, Steel Sprockets (Front 1 tooth down)