SOLIDWORKS Flow Simulation: Particle Study

Learn how to setup particle studies in SOLIDWORKS Flow Simulation to simulate the presence of liquid or solid particles traveling in a fluid. The particle study is defined on top existing flow results, hinging on the assumption that the injected particles will be few and small enough such that they do not influence the overall flow pattern. This means it is possible to simulate injection of many different combinations of particles, without having to re-run the overall flow simulation, Two different applications are discussed for predicting accretion / accumulation rate as well as erosion. Key considerations to ensure accuracy are covered such as setting an adequate number of points and appropriate constraints to manage particle lifetime.

Presented by Ryan Navarro

Learn more about our Simulation solutions: https://bit.ly/3OcCkWw

0:00 Introduction
0:45 Particle Study with Wizard
2:15 Constraints (Lifespan of particle)
4:00 Additional Particle Injections
6:08 Accumulation Rate
7:46 Erosion Particle Study Setup
9:05 Number of Starting Points