Модуль Mosfet P-канала на 22 А. Модуль драйвера двигателя постоянного тока MOSFET на 22 А.

@radal05


00:00 Radal 05
00:12 Skematik Modul Driver Motor DC MOSFET 22A
01:44 Tes

Modul Mosfet 22A canal P Modul Driver Motor DC MOSFET 22A
Input Voltage Control: 3.3 V-12 V
Voltage output charged: 5-36 V
Use the insulated opto board, completely separated from the voltage of two terminals.
Input is controlled by a 2-pin control, a ground control can be directly connected to the control switch.
Current control 1-5MA control voltage is different, the current difference is mainly the loss in the LED.
Loaded with the current maximum: 22A, more than 5A need to add a heatsink.
Plate with LED lights
Input and output terminal screw terminal block
control terminal using 2.54mm pin, easy wiring.
control can be directly connected microcontroller IO. MCU can for ARDUINO PWM engine speed control, the brightness of the lights and so on. Note that large current needs to add additional heat sink
plate size: 4.2X2.6 cm